Turntables Slewing Rings Bearing Made In China

September 19, 20220

Turntables Slewing Rings Bearing Made In China

Necessity and Adjustment Method of Gear Clearance Adjustment of Turntables Slewing Rings Bearing

First. Necessity of gear clearance adjustment of turntables slewing rings bearing
​​
1. Different applicable work scenarios for turntables slewing rings bearing
​​
The size of the gear clearance of the turntables slewing rings bearing is related to the characteristics of the gear transmission. When the gear transmission is used for heavy-duty work, the gear clearance needs to be larger. The gap should be smaller.
​​
2. Improper gear clearance affects normal work

turntables slewing rings bearing Alt.
​​
The gear transmission of tower cranes and excavators is not only required for heavy-duty work, but also requires frequent forward and reverse rotation, and the speed is not high.

Whether the clearance is too large or the clearance is too small, it will have adverse effects. If the gear gap is too large, the operation of these equipment will not be very smooth, and the gear wear will be more serious;

if the gear gap is too small, the lubricating oil film between the slewing bearing gear and the slewing reducer gear will be destroyed, causing The friction between the two becomes larger, and the tooth surface wears faster.

Coupled with manufacturing errors and elastic deformation of the turntable, it is very likely that the gear will be stuck.
​​
Therefore, for heavy machinery such as tower cranes and excavators, in order to ensure the reliability of equipment rotation, it is very necessary to keep the gear gap of the turntables slewing rings bearing at a moderate size and debug it according to the actual working conditions.

Second, the turntables slewing rings bearing gear gap adjustment method
​​
1. Meshing tightly to adjust the gap
​​
In the position with high gear meshing tightness, adjust the gear backlash to the rated value. The value of this value should be adjusted strictly according to the given value, otherwise it may cause damage to the turntable slewing rings bearing.

In addition, in the process of gear clearance adjustment, it is also necessary to pay attention to the position of the teeth.
​​
2. Use feeler gauge to measure and adjust
​​
When the radial runout of the slewing bearing gear reaches a high point, the gear gap can be measured with a feeler gauge. If the gap is different from the given value, the slewing reducer gear can be moved to change the center of the slewing reducer gear and the slewing bearing gear. Correct the distance.

If the slewing reducer gear cannot be moved, it can be adjusted by moving or re-fixing the turntables slewing rings bearing. After debugging, let the slewing bearing rotate a few times to see if the adjusted clearance meets the requirements. If there is a radial jump of the gear to a higher point, it should be marked and adjusted again.
​​
When adjusting the turntables slewing rings bearing gear clearance, if there is no gnawing between the slewing bearing gear and the slewing reducer gear, and the slewing mechanism can run smoothly, it means that the gear clearance has been adjusted properly.


Leave a Reply

Your email address will not be published. Required fields are marked *


About us

Headquarters

Luoyang MC Bearing Technology Co.,Ltd (LYMC)
+86 13837949030

www.chinaslewingbearings.com/

export@lymcbearings.com

LOCATIONS

We are everywhere




GET IN TOUCH

Follow our activity

LYMC bearings are the perfect alternative to the most common and well-known brands.